Skip to main content
|For Asia / Oceania market|
|For European market|
|Following on-demand products are available.
Twin hook type, Optional control voltage, With overload limiter, With emergency stop button, Large capacity type(20t), Low headroom type, Optional power source for chain hoist and trlley, With plated chain , With UDS switch, Dual speed trolley, etc.
Manual Type and Motorized Type
|For traveling of the ceiling crane, Max. wheel load from 0.6 ton to 11.2 ton.
(Suspension Type, Toprun Type and Wheel Unit)
|Useful references when you select or install the chain hoist.
(Calculation formulas for the chain hoist selection, Maximum Span of the I-Beam for Traveling, Hook Dimensions, and Weight of Load Block and Chain)
||Definition, Type, Purpose, Structure and Term|
|Specifications||S, F Series|
|Electric Source||3-Phase: 220V / 380 to 415V 50Hz
1-Phase: 220 to 240V 50Hz
|Operation Method||Operating push button|
|Power Feeding System||
|2points||( For single speed)
( For dual speed)
|4points||For single speed|
|For dual speed|
|6points||For single speed|
|For dual speed|
|Color (Munsell Color)||Orange(2.5YR 6/12)|
|Electrical Protection||JP44(When drain hole is sealed):Indoor Type|
|Insulation class of Motor||Class E|
|Max.No.of starts per hour||150 starts/h|
|Approval||Japanese Industrial Standard|
Operationg enviroment, time and frequency must be considered when you select the chain hoist.
|Load Condition||Mean operating hour per day (h)|
Light : Usually being subjected to around 1/3 of rated load, and rated load in exceptional.
Medium : Usually being subjected to around a half of rated load, and rated load sometimes.
Heavy : Usually being subjected to around 2/3 of rated load, and rated load frequently.
Severe : Usually being subjected to rated load.
F series hoists equipped with auxiliary brake.
used where practical to provide quiet operation.
Disk type Electro-Magnetic brake system for steady operation and long life
F series hoists
are equipped with patented Automatic Ajusting Brake for easier maintenance and added safety.
interrrupt motor power to prevent hook overtravel and hazardous condition such as chain kink.
reduce maintenance time and installation.
with mechanical-interlocking against line short by mechanical shock.
cut control circuit when reverse phasing.
as standard part for safer operation.
special (paterned) alloy steel chain surface hardeded for optimum strength and wear resistance.
(DIN-5684-8)(U.S. PAT. 3830054)
is heart-treated and equipped with safety latch and 360° swivelling.
is molded with strain relief wire rope into one body. This assures easier and safer operation.
is rain-proof plastic for severe impact and corrosive atmosphere resistance and mechanically interlocked.The 24 volt control circuit reduce shock hazard to the operation.
|For Europian market|
|Emergency stopping button is available in order to stop Chain Hoist in an emergency case.|
Unique, patented over load protection device is available on all models upon request.
Fuse is built in a primery side to prevent overheat.