Model item, unit |
Without Dryer Model | Dryer built-in Model | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| DSP-37VAT5 DSP-37VAT6 |
DSP-55VAT5 DSP-55VAT6 |
DSP-75VA5L(M) DSP-75VA6L(M) |
DSP-37VATR5 DSP-37VATR6 |
DSP-55VATR5 DSP-55VATR6 |
||||||||
| Discharge air pressure | MPa | 0.69 | 0.88 | 0.69 | 0.88 | 0.69 | 0.88 | 0.69 | 0.88 | 0.69 | 0.88 | |
| Capacity | m3/min | 5.3 | 4.6 | 8.5 | 6.7 | 11.8 | 10.1 | 5.3 | 4.6 | 8.5 | 6.7 | |
| Intake air pressure temperature | °C | Atmospheric Pressure/0-40 | Atmospheric Pressure/5-40 | |||||||||
| Driving method | — | V-belt + Gear-driven | Direct coupling + Gear-driven |
V-belt + Gear-driven | ||||||||
| Capacity control system | — | Inverter control + purge control | ||||||||||
| Discharge air temperature | °C | Atmospheric temperature + 15 or less | ||||||||||
| Discharge pipe diameter | B | 1 1/2 | 2 (Flange) | 1 1/2 | ||||||||
| Motor Output | kW | 37 | 55 | 75 | 37 | 55 | ||||||
| Motor type | — | 4-pole TEFC Motor | 2-pole TEFC Motor | 4-pole TEFC Motor | ||||||||
| Starting Method | — | Inverter | ||||||||||
| Cooling fan motor output | kW | 0.75 | 1.5 | 0.9 × 2 | 0.75 | 1.5 | ||||||
| Coolant pump motor output | kW(50/60Hz) | — | 0.2/0.3 | — | — | 0.2/0.3 | ||||||
| Oil pump Output | kW | — | 0.4 | — | — | 0.4 | ||||||
| Lubricating oil capacity | L | 18(Not filled in) | 22(Not filled in) | 35(Not filled in) | 18(Not filled in) | 22(Not filled in) | ||||||
| Dryer | Dew point of outlet air | Celsius | — | Lower than 10 (Ambient temp.30 celsius) | ||||||||
| Chiller output | kW | 1.1 | 2.2 | |||||||||
| Refrigerant | — | HFC-R407C | ||||||||||
| Fan motor output | W | 25 × 2 | 20 × 4 | |||||||||
| Weight | kg | 1,200 | 1,630 | 2,400 | 1,350 | 1,780 | ||||||
| Dimensions (W × D × H) | mm | 1,780 × 980 × 1,500 | 2,100 × 1,150 × 1,530 | 2,850 × 1,320 × 1,580 | 2,180 × 980 × 1,500 | 2,550 × 1,150 × 1,530 | ||||||
| Noise level (1.5m from front side) | dB[A] | 67 | 67 | 69 | 71 | 74 | 75 | 67 | 67 | 69 | 71 | |
Note
- *1
- Capacity is the converted value at its inlet condition.
- 2
- The appearance and specifications are subject to change without prior notice.
- 3
- Do not use any of the compressors with a respiratory device that directly sucks compressed air.
- 4
- Motor output is the nominal output.
- 5
- The discharge air pressure is the gauge pressure.
- 6
- Sound level is the value in an anechoic room from 1.5m at full load.
- 7
- Install the compressor indoors in an atmosphere free of explosive and corrosive gases and at a place not exposed to excessive moisture or dust.