Without Dryer model
Model item, unit |
DSP-22VA5I DSP-22VA6I |
DSP-37VA5I DSP-37VA6I |
DSP-55VA5I DSP-55VA6I |
||
|---|---|---|---|---|---|
| Rated specs | Discharge air pressure | MPa | 0.69 | ||
| Capacity | m3/min | 3.4 | 4.2 | 6.4 | |
| In PQ wide mode | Discharge air pressure | MPa | 0.39 | 0.49 | 0.39 |
| Capacity | m3/min | 4.3 | 5.0 | 8.2 | |
| Operating range of PQ wide mode | MPa | 0.39 - 0.69 | 0.49 - 0.69 | 0.39 - 0.69 | |
| Intake air press./temp. | °C | Atmospheric pressure /0-40 | |||
| Driving method | — | V-belt + Gear-driven | |||
| Capacity control method | — | Inverter control + purge control | |||
| Discharge temperature | °C | Atmospheric temperature + 15 or less | |||
| Discharge pipe diameter | B | 1 | 1-1/2 | ||
| Motor output | kW | 22 | 37 | 55 | |
| Motor type | — | 4-pole TEFC Motor | |||
| Starting method | — | Inverter | |||
| Cooling fan motor output | kW | 0.75 | 0.75 | 0.9 | |
| Cooling pump motor output | kW | 0.2/0.3 | |||
| Lubricating oil capacity | L | 12(Not filled in) | 18(Not filled in) | ||
| Weight | kg | 850 | 1,080 | 1,180 | |
| Dimensions (W×D×H) | mm | 1,650 × 970 × 1,400 | 1,780 × 980 × 1,500 | ||
| Noise level (1.5m from front side) | dB[A] | 63 | 66 | 68 | |
Dryer built-in model
Model item, unit |
DSP-22VAR5I DSP-22VAR6I |
DSP-37VAR5I DSP-37VAR6I |
DSP-55VAR5I DSP-55VAR6I |
||
|---|---|---|---|---|---|
| Rated specs | Discharge air pressure | MPa | 0.69 | ||
| Capacity | m3/min | 3.4 | 4.2 | 6.4 | |
| In PQ wide mode | Discharge air pressure | MPa | 0.49 | ||
| Capacity | m3/min | 4.0 | 5.0 | 7.6 | |
| Operating range of PQ wide mode | MPa | 0.49 - 0.69 | |||
| Intake air press./temp. | °C | Atmospheric pressure /5-40 | |||
| Driving method | — | V-belt + Gear-driven | |||
| Capacity control method | — | Inverter control + purge control | |||
| Discharge temperature | °C | Atmospheric temperature + 15 or less | |||
| Discharge pipe diameter | B | 1 | 1-1/2 | ||
| Motor output | kW | 22 | 37 | 55 | |
| Motor type | — | 4-pole TEFC Motor | |||
| Starting method | — | Inverter | |||
| Cooling fan motor output | kW | 0.75 | 0.75 | 0.9 | |
| Cooling pump motor output | kW | 0.2/0.3 | |||
| Lubricating oil capacity | L | 12(Not filled in) | 18(Not filled in) | ||
| Dryer | Dew point of outlet air | °C | 10 or less (ambient temperature, 30°C; during a rated run) |
||
| Chiller output | kW | 1.1 | 1.1 | ||
| Refrigerant | — | HFC-R407C | |||
| Amount of refrigerant | g | 360 | 600 | ||
| Fan motor output | W | 25 | 120 | ||
| Weight | kg | 880 | 1,230 | 1,330 | |
| Dimensions (W×D×H) | mm | 1,650 × 970 × 1,400 | 2,180 × 980 × 1,500 | ||
| Noise level (1.5m from front side) | dB[A] | 63 | 66 | 68 | |
Note
- *1
- The values of discharge air content are converted ones corresponding to suction conditions.
- 2
- If you wish to guarantee the amount of air emission, please make a separate contract.
- 3
- The values of noise level were measured in full load operation in an anechoic room. When operating in PQ wide mode, there is an increase of appx. 3dB.
- 4
- The dew point of outlet air was measured at 30°C of ambient temperature and 45°C of suction air temperature. When operating at lowest pressure within PQ wide mode range, there is an increase of appx. 3°C
- 5
- When operating at pressure lower than the PQ wide mode range, the air dew point at the exit of interior dryer is increased appx. 6°C. When an air dew point of less than 10°C is required use supplementary dryer.
- 6
- The external appearance and specs could be changed without notice.
- 7
- Do not use any of the compressors with a respiratory device which directly sucks compressed air.
- 8
- Motor output designates nominal output.
- 9
- The discharge pressure implies gauge pressure.
- 10
- Install the compressor indoors in an atmosphere free of explosive and corrosive gases and at a place not exposed to excessive moisture or dust.